Once the program was ready on the home screen, participants set the parameters. The parameters were: duration time- ten-seconds, cursor type- your choice, and line altitude- vertical. Following the measurements displayed in Table 2, set Movement Amplitude and Target Width corresponding to each trial. The participant then utilized the Fitts’ Tapping Test Software with a computer mouse (Figure 1). There were two conditions that the participants performed: condition one, consisted of using the dominant hand of the participant and condition two, using the non-dominate hand. The participant then performed five trials of each condition adjusting movement amplitudes and target widths to correspond with the ID levels. The goal of the experiment was clicking each target area as fast as possible in the ten-second duration. After each condition, the participant recorded the number of taps that were successfully completed during the set amount of time (Table 3 and Table 4). Afterwards they established movement time (seconds) and group mean. Movement time was calculated by dividing the number of taps by duration of each trial; in this case the duration of the trial was
Once the program was ready on the home screen, participants set the parameters. The parameters were: duration time- ten-seconds, cursor type- your choice, and line altitude- vertical. Following the measurements displayed in Table 2, set Movement Amplitude and Target Width corresponding to each trial. The participant then utilized the Fitts’ Tapping Test Software with a computer mouse (Figure 1). There were two conditions that the participants performed: condition one, consisted of using the dominant hand of the participant and condition two, using the non-dominate hand. The participant then performed five trials of each condition adjusting movement amplitudes and target widths to correspond with the ID levels. The goal of the experiment was clicking each target area as fast as possible in the ten-second duration. After each condition, the participant recorded the number of taps that were successfully completed during the set amount of time (Table 3 and Table 4). Afterwards they established movement time (seconds) and group mean. Movement time was calculated by dividing the number of taps by duration of each trial; in this case the duration of the trial was