Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
24 Cards in this Set
- Front
- Back
Name 3 types of diagnostic radiographic tube-support systems.
|
Overhead, floor-to-ceiling, floor, mobile, and C-arm
|
|
Whatare the 2 types of incoming line current?
|
Single phase and three phase
|
|
How many pulses are there per Hz for 1 phase and 3 phase power?
|
single = 2 pulses
three = 3 pulses |
|
What devise in the x-ray circuit controls kVp? mA? time?
|
kVp = autotransformer
mA = variable resistor time = timer circuit |
|
What is the approximate voltage ripple for 1 phase 2p equipment? 3 phase 6P? 3 phase 12P?
|
1/2 pulse = 100%
3/6 pulse = 13-25% 3/12 pulse= 4-10% |
|
What happens to the tube mA during an exposure using a falling load generator?
|
permits a greater use of the acceptable tube limits
|
|
What is the difference b/w an ionization chamber and a phototimer?
|
Ionization chambers is a gas-filled enclosure containing + and - electrodes that measures the amt of radiation passing through the enclosure according to the degree of ionization caused by the radiation. Phototimer is a photoelectric device that automatically controls photographic exposures
|
|
What factor determines the minimum reaction time?
|
it is determined by the length of time necessary for the AEC to respond to the radiation and for the generator to terminate the exposure.
|
|
What is the approximate % of electron energy that is converted ot x-ray photon energy int ethe x-ray tube?
|
99 percent
|
|
The majority of the electron energy in the e-ray tube is converted to what from of energy?
|
Heat
|
|
Describe a bremsstrahlung target interaction?
|
Occurs only when the incident electron interacts with the force field of the nucleus.
|
|
Describe a characteristic target interaction.
|
Occurs only when the incident electron interacts with an inner shell electron
|
|
What is a characteristic cascade?
|
An outer shell electron has dropped to fill the hole & another electron will drop to fill that hole it left & so on until only the outermost shell is missing an electron.
|
|
What is the average keV of the primary beam as compared to the kilovoltage peak?
|
30-40%
|
|
What effect does increasing mAs have on the total x-ray emission spectrum?
|
mAs controls the quanity of electrons striking the target the result is a change in the amplitude of the emission graph.
|
|
What effect does increasing kVp have on the total x-ray emission spectrum?
|
kVp controls the quality of the electrons striking the target resulting in a change in the # of higher energy photons & amplitude of the emission graph.
|
|
Define attenuation
|
the reduction in the # of x-ray photons in the beam and subsequent loss of energy as the beam passes through matter
|
|
Describe the photoelectric absorption interaction.
|
is when an x-ray photon interacts with an inner shell electron, the photon ejects the electron from is inner shell & is totally absorbed in the interaction
|
|
Describe the Compton scatter interaction
|
occurs when an incident x-ray photon interacts with a loosely bound outer-shell electron removes the electron from its shell & then proceeds in a different direction as a scattered photon.
|
|
What is backscatter?
|
is when a scattered photon is deflected back toward the source it is traveling in the direction opposite to the incident photon
|
|
What are the two interactions which have a significant impact on the radiographic image?
|
photoelectric absorption and Compton scattering
|
|
What type of radiographic contrast will result if the prevalent interaction is photoelectric absorption?
|
High-contrast images
|
|
Describe the coherent scatter interaction
|
is an interaction which occurs b/w very low energy x-ray photons and matter
|
|
What type of radiographic contrast will result if the prevalent interaction is Compton scatter?
|
Low-contrast images.
|