Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
10 Cards in this Set
- Front
- Back
375 F to 500 F
|
The filler metals used for soldering usually melt as a temperature range of:
|
|
Lower than
|
The melting point of the filler metal used for soldering or brazing must be ___________ the two metals that are being joined.
|
|
Allways contains lead
|
Which of the following is not a characteristic of the filler metal (solder) used for soldering?
|
|
95% tin, 4% antimony
|
The most commonly used solder for refrigeration tubing consists of:
|
|
Indicate the temperature of the metal
|
Which of the following is not a characteristic of both soldering and brazing fluxes?
|
|
1,200 F to 1,550 F
|
The filler metals used for brazing usually melt at a temperature range of:
|
|
2,000 psig
|
The oxygen cylinder used with oxyacetylene heating equipment contains oxygen stored at a pressure of about:
|
|
15 psig
|
When using oxyacetylene heating equipment for brazing, the acetylene regulator should never be adjusted to supply a pressure higher than:
|
|
Neutral
|
The _____________ flame is used for almost all brazing applications.
|
|
Nitrogen
|
To safely purge tubing while brazing, the tubing should be purged with:
|